August Club Stamp Project - Snowmen Bendy Card

Good morning,

 

Here is the newly launched 'Three Sparkly Snowmen' stamp set which is the club stamp set for August.

 

Here below, is the project featured in the club packs this month.  Heidi has designed a 'bendy' card, using two of the snowmen from the set. We have listed the products used and instructions on how to make the card.

 

 

 

The stamp set front looks like this :

 

 

 Products Used :

August Club 'Three Sparkly Snowmen' Stamp set
Blue card
Craft Creations 'Snowflake' paper
White stamping card
Memento 'Rich Cocoa' inkpad
Tim Holtz 'Blue Jeans' inkpad
Promarker pens
Snowflake die
Bling stones
Stickles glitter glue

Card Instructions :

(1) Cut three pieces from the blue card. Measure  : 14cms x 10.5cms, 14cms x 6.5cms and 14cms x 4.5cms.
(2) On the larger oblong of blue card, score vertically at : 1cm and 12.5cm. Score the smaller oblong vertically at : 1.5cms and 13cms.
(3) Cut three pieces from the 'Snowflake' paper. Measure : 13.5cms x 10cms, 11cms x 5.5cms and lastly,
11cms x 4cms.
(4) Using white stamping card, cut an oblong to measure : 12.5 x 9.5cms.  On this piece, stamp up your 'Snowmen' image of choice on left-hand side of card.
(5) Colour in with pens of choice and stamp sentiment on right of card, centrally.
(6) Using each blue flap of card, stick larger oblong to left of card with 1cm flap being stuck to back of card base.
(7) Stick smaller flap onto right of card, as before.
(8) Stick paper down to card base and flaps.
(9) Stick card image down to base of card.
(10) Cut edges of both flaps, ready to sit into slits on card.
(11) On card base, cut a vertical slit into card 1.5cms from bottom edge and approximately 10.5cms from left edge of card.

Making sure that flap will fit into slit and is cut straight so that card stands.
(12) Onto larger flap, cut a slit through paper and card, 1.5cms approximately from card base and 4cms from left edge. 

Make sure that the slits are slightly larger in length than flap and are flush with bottom edge of card.
(13) Stamp up sentiment onto white card piece and matt onto a blue matt.
(14) Stamp up snowman with hat image, colour in and cut out.  Stick to front of card.
(15) Place snowflake onto card edge and sentiment over edge of flap.
(16) Cover selected areas with Stickles glue and add bling stones to card.

 

We do hope you have enjoyed the tutorial today, if you wish to visit our website, please hop on over via the link HERE.

 

The Little Claire Team

 

xxxxx